Billion Electric Company 2073 user manual Device Overview, Det Led

Device Overview

BiPAC 2073		BiPAC 2074
	1.0 DET LED		AC Power
			Outlet / /
				AC Pass-
	Power LED		thru (only
			available in
	PLC LED		BiPAC 2074)
	ETH LED
	Sync Button
	Reset Button
	Ethernet Port
	Power Plug

The Description of each labeled part is described in the table below.

AC Outlet / AC Pass-	Filtered AC Pass-through available for electrical devices with Input:
thru (only available in	100~240V AC, 50~60Hz, 6Amp (Maximum).
BiPAC 2074)
1.0 DET LED	Blinking when detecting other HomePlug 1.0 devices that have the
	transmission rate of 14 or 85 Mbps.
	Note: Due to the incompatibility of HomePlug AV 200 with
	HomePlug 1.0 devices, the presence of the HomePlug 1.0 devices
	within the powerline network will thus reduce the performance of
	your powerline network.
Power LED	Lit when the device is power on.
	Blinking when the device enters power saving mode.
	Lit off when power is off.
PLC (Powerline Link/	Lit when the power line sync is established.
Act) LED	Blinking when networking is active.
ETH (Ethernet Link/	Lit when connected to an Ethernet device.
Act) LED	Blinking when data is transmitted or received via Ethernet port.
Sync Button	Used to establish a LAN network with other Ethernet devices.
Reset Button	Press this button to for more than 2 seconds to reset device to factory
	default settings.
Ethernet Port	Connect the HomePlug AV device with an Ethernet device (e.g.
	computer, router, hub/switch , IP pone, IPTV set-top-box, gaming
	consoles…), using the RJ-45 Ethernet cable included.
Power Plug / AC Power	Plug into an AC outlet for power supply and to build a powerline
Cord	network with other HomePlug AV devices.

6