D-Link DP-311u manual 03/17/03

Page 74

Governing Law: This Limited Warranty shall be governed by the laws of the State of California. Some states do not allow exclusion or limitation of incidental or consequential damages, or limitations on how long an implied warranty lasts, so the foregoing limitations and exclusions may not apply. This limited warranty provides specific legal rights and the product owner may also have other rights which vary from state to state.

Trademarks: D-Link is a registered trademark of D-Link Systems, Inc. Other trademarks or registered trademarks are the property of their respective manufacturers or owners.

Copyright Statement: No part of this publication or documentation accompanying this Product may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from D-Link Corporation/D-Link Systems, Inc., as stipulated by the United States Copyright Act of 1976. Contents are subject to change without prior notice. Copyright© 2002 by D-Link Corporation/D-Link Systems, Inc. All rights reserved.

CE Mark Warning: This is a Class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.

FCC Statement: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

IMPORTANT NOTE:

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of about 8 inches (20cm) between the radiator and your body.

This transmitter must not be co-located or operated in conjunction with any other antenna or transmiter.

Register your D-Link product online at http://support.dlink.com/register/

(03/17/03)

74

Image 74
Contents Link DP-311U Contents Package Contents Introduction NetBEUI AppleTalkPower Power / USBLED Indicators Ethernet/WLANAntenna Power Reset Network Cable ConnectorDC Power Connector RJ-45Wireless Basics Installation Considerations Standards-Based TechnologySetting up the DP-311U Power on Self-Test Faulty ComponentGetting Started Using the Web Configuration Home Configuration Page Network Network Tools Help TCP/IP Printing for Windows XP Select your Connection Mode TCP/IP Printing for Windows XPTCP/IP Printing for Windows XP Go to Start Settings Printers and Faxes Add a Printer Select Local Printer Standard TCP/IP PortSelect Custom Click Next Click Finish TCP/IP Printing for Windows XP TCP/IP Printing for Windows TCP/IP Printing for Windows TCP/IP Printing for Windows Go to Start Settings Printers Printer iconHighlight Standard TCP/IP Port Select Custom Click Next Click Finish TCP/IP Printing for Windows Select Do not share this printer TCP/IPPrinting For Windows 98SE/Me TCP/IP Printing for Windows 98SE/Me TCP/IP Printing for Windows 98SE/Me Go to Start Settings Control Panel Select the letter Representing TCP/IP Printing Click Properties Click Add Port Windows will ask for Restart Click Yes Start Settings Printers Add Printer Click Next Select Yes to print a test Click Finish Unix/Linux Printing Network Setting up Apple Talk or LPR Printing in Mac OSPreferences Setting up Apple Talk or LPR Printing AppleTalk ActiveClick Add Printer Click Print to print your document LPR Printers using IP protocol Setting up Apple Talk Printing Mac OSPrinting from MacOS Client Workstations Printing from MacOS Client Workstations Select PPDUsing the Network Setup Wizard in Windows XP Networking BasicsNetworking Basics Enter a Computer description and a Networking Basics Format the disk if you wish, and Click Next Networking Basics Ready to use How to assign a Name to your computer How to find your IP Address in Windows XP Computer nameSupport tab Control PanelProperties Network ConnectionsConnections Assigning a Static IPAddress Windows XP/2000 „ Click Internet Protocol TCP/IP „ Click PropertiesTechnical Specifications Printer ConnectionTechnical Support Warranty and Registration Page 03/17/03 DP-311U Printer Compatibility List For Windows Appendix DP-311UPrinterCompatibilityList for Windows
Related manuals
Manual 76 pages 61.89 Kb