INSTALLATION
2.3INSTALLATION
Install the THN-MIM into the MMAC as follows:
CAUTION: Observe all electrostatic precautions when handling the THN-MIM. Static discharges will damage the module.
1.Remove the unit from the shipping box.
2.Slide the two foam end caps off the unit.
3.Remove the unit from the protective plastic bag and set the THN-MIM in a static free area. Save the shipping box and materials in case the module has to be reshipped.
4.Slide the module into the MMAC card cage.
5.Secure the module to the MMAC by turning the knurled knobs.
CAUTION: Be sure the THN-MIM is firmly attached to the MMAC by turning the knurled knobs. Failure to do so may result in improper operation.
Install the thick or thin-net cable segment(s) to the BNC ports(s) on the module. If a thick-net cable segment is attached to a port on the module, a BNC to N-Series adaptor must be attached to the port.
The THN-MIM is now ready for operation. It is recommended that the segments be tested prior to transmitting data. Refer to Section 3.2 -
INSTALLATION CHECKOUT.