Extron electronic TP R AV Furniture mounting, For through-surface mounting all except TP R 15HD a

Installation and Operation, cont’d

TP R 15HD A only — For optional rack mounting, mount the receiver on a VersaTools 19" 1U Rack Shelf (Extron part #60-190-20) (figure 2-4). The TP R 15HD A mounts in one of four locations on the rack.

RGB
LEVEL
TP PEAK		ING
R
	15H
		D A

VersaTools Rack Shelf		VEL
	LE	RGB

TP PEAK		ING
R
	15H
		D A

1/4 Rack Width False Front

Face Plate

Use 2 Mounting Holes on	LEVEL
	RGB
	TP PEAK	ING
Opposite Corners	R
	15H	D A
		(2) 4-40 x 3/16" screws

Figure 2-4 — VersaTools rack mounting the TP R 15HD A

1.	If feet were previously installed on the bottom of the
	receiver, remove them.
2.	Mount the receiver on the rack shelf, using two 4-40 x 3/16
	screws in opposite (diagonal) corners to secure the receiver
	to the shelf.
3.	Install blank panel(s) (included in the 1U universal and
	VersaTools rack kits, optional for the 1U basic rack kit) or
	other unit(s) to the rack shelf.

Only the TP R 15HD A and products in the Extron VersaTools line can be mounted on a VersaTools shelf. Any 1U rack-mountable Extron product can be mounted on the standard shelf.

Furniture mounting

All of the receiver models can be mounted under furniture such as a table or podium surface using the appropriate optional mounting bracket, Extron’s Mini Under-Desk Mounting Kit (part #70-212-01) (TP R 15 HD A) or Under-Desk Mounting Kit

(part #70-077-01) (all other models).

All models except the TP R 15HD A can be mounted through a table or podium using Extron’s Through-Desk Mounting Kit (part #70-077-02). Furniture mount the receiver as follows:

1.	Attach the mounting brackets to the receiver with the
	machine screws provided (figure 2-5).
	CNYSCGOS

Extron
TP R BNC A	Extron
	TP R 15HDA

Through-desk

Mounted

Extron
TP R BNC A
R
GB
LE
VEL
PE
TP R	AKING
	15HD A

Under-desk

Mounted

Under-desk

Mounted

Figure 2-5 — Under-desk or through-desk mounting

2.	For through-surface mounting (all except TP R 15HD A),
	cut the proper sized hole in the mounting surface.
3.	Hold the receiver with the attached brackets against the
	underside of the table or other furniture. Mark the
	location of the screw holes of the bracket on the mounting
	surface.
4.	Drill 3/32” (2 mm) diameter pilot holes, 1/4” (6.3 mm)
	deep in the mounting surface at the marked screw
	locations.

2-8 TP Receivers • Installation and Operation TP Receivers • Installation and Operation 2-9