FOX |
Command | ASCII command | Response | Additional description |
| (host to switcher) | (switcher to host) |
|
|
|
|
|
Information requests |
|
|
|
Information request | I | VX%XX^•AX%XX^ •SX&1X&2...X&8] | |
Remote
4G Matrix 14400 • Refer also to the FOX 4GMatrix |
Request part number | N |
Request part number and Board | *N |
configuration |
|
VX%XX^shows the number of available inputs and outputs for this configuration. AX%XX^has no meaning for this product. SX&1X&2...X&8 shows the board type installed in each slot.
Control, cont’d
14400 User’s Manual at | Remote Control |
www.extron.com. |
|
Query controller firmware version | Q |
| X*] |
|
Example: | Q |
| 1.23] | The |
|
|
|
| version is 1.23 (sample value only). |
|
|
|
| |
N X%= Inputs |
| Total number of inputs for this switcher |
| |
X^= Outputs |
| Total number of outputs for this switcher |
| |
X&= Board installed |
| 0 | = No board installed |
|
|
| 1 | = 16x16 multimode board |
|
|
| 2 | = 16x16 singlemode board |
|
|
| x = Unknown board or mix of transceivers installed |
| |
X*= Firmware version number to second decimal place (x.xx)
Command | ASCII command | Response | Additional description |
| (host to switcher) | (switcher to host) |
|
Refer also to the FOX 4G | FOX |
Matrix 14400 User’s Manual at | 4G Matrix 14400 • |
www |
|
IP setup
Set IP address Read IP address Set subnet mask Read subnet mask Set gateway IP address Read gateway IP address Set DHCP on or off Read DHCP on/off status Set verbose mode
Read verbose mode
Configure current port timeout Read current port timeout Configure global IP port timeout Read global IP port timeout
EX(CI} IpiX(]
ECI} X(]
EX(CS} IpsX(]
ECS} X(]
EX(CG} IpgX(]
ECG} X(]
EX1)DH} IdhX1)]
EDH} X1)]
EX1!CV} VrbX1!]
ECV} X1!]
E0*X1@TC} Pti0*X1@]
E0TC} X1@]
E1*X1@TC} Pti1*X1@]
E1TC} X1@]
.extron | Remote |
.com. | Control |
N X(= IP address | ###.###.###.### | |
X1)= DHCP | 0 | =1 off, 1 = on |
X1!= Verbose mode | 0 | = clear/none (default for Telnet connection) |
| 1 | = verbose mode (default for |
| 2 | = tagged responses for queries |
X1@= Port timeout interval | 3 | = verbose mode and tagged for queries |
1 | (= 10 seconds) - 65000 (default is 30 = 300 seconds = 5 minutes) | |