DVI DA2 and DVI DA4 Setup Guide (Continued)
Step 3 — Power Cable Connections
Connect the 12 VDC power supply to the power receptacle of the unit.
POWER
12V Smooth Ridges
0.4A MAX
A | A |
| SECTION |
Power Supply
Output Cord
DC Power Cord
Captive Screw Connector
Ground +12 VDC
External
Power Supply
(12 VDC, 1 A )
AC Power Cord
CAUTION: This product is intended to be supplied by a Listed Power Unit marked “Class 2” or “LPS”, rated 12 VDC, maximum 1.0 A. Always use a power supply supplied or specified by Extron. Use of an unauthorized power supply voids all regulatory compliance certification and may cause damage to the supply and the end product.
Unless otherwise stated, the AC/DC adapters are not suitable for use in air handling spaces or in wall cavities. The power supply is to be located within the same vicinity as the Extron A/V processing equipment in an ordinary location, Pollution Degree 2, secured to the equipment rack within the dedicated closet, podium, or desk.
The installation must always be in accordance with the applicable provisions of National Electrical Code ANSI/NFPA 70, article 75, and the Canadian Electrical Code part 1, section 16. The power supply shall not be permanently fixed to building structure or similar structure.
NOTES: The length of the exposed wires in the stripping process is critical. The ideal length is
3/16 inches (5 mm). If the exposed section is longer, the exposed wires may touch, causing a short
circuit between them. If it is shorter, the wires can be easily pulled out even if tightly fastened by the captive screws.
Do not tin the wires. Tinned wire does not hold its shape and can become loose over time.
Step 4 — Applying Power
NOTE: Output 1 is used as DDC reference and Hotplug Detect and a local monitor must be |
connected to it before the source device is powered on. Since Output 1 is used for reference, all |
displays connected to the other outputs must be capable of handling resolutions greater than or |
equal to that of Output 1. |
•Power on the local monitor.
•Power on the display devices.
•Power on the source input device.
Extron USA - West
Headquarters
+800.633.9876
Inside USA / Canada Only
+1.714.491.1500 +1.714.491.1517 FAX
Extron Europe | Extron Asia | Extron Japan | Extron China |
+800.3987.6673 | +800.7339.8766 | +81.3.3511.7655 | +400.883.1568 |
Inside Europe Only | Inside Asia Only | +81.3.3511.7656 FAX | Inside China Only |
+31.33.453.4040 | +65.6383.4400 |
| +86.21.3760.1568 |
+31.33.453.4050 FAX | +65.6383.4664 FAX |
| +86.21.3760.1566 FAX |
|
|
|
|
© 2010 Extron Electronics. All rights reserved. www.extron.com
Extron Middle East
+971.4.2991800 +971.4.2991880 FAX
Rev C
04 10