Extron electronic Extender Series manual Sync, Audio input, Audio output

Page 35

Sync

Input type	RGBHV, RGBS, RGsB, RsGsBs, bi-level
	and tri-level component video sync
Output type	RGBHV, RGBS, RGsB, RsGsBs, bi-level
	and tri-level component video sync
Input level	2.0 V to 5.0 Vp-p
Output level	TTL: 5 Vp-p, unterminated
Input impedance	510 ohms
Output impedance	75 ohms
Max. propagation delay	18.8 ns
Max. rise/fall time	4 ns
Polarity	Positive or negative (follows input)

PRELIMINARY

Audio

Gain	Unbalanced output: 0 dB; balanced output:
	+6 dB
Frequency response	20 Hz to 20 kHz, ±0.5 dB
THD + Noise	0.025% @ 1 kHz, 0.020% @ 20 kHz at
	nominal level
S/N	>90 dB at rated maximum output
Stereo channel separation	>75 dB @ 20 Hz to 20 kHz

Audio input

Number/signal type	1 stereo, unbalanced
Connectors	(1) 3.5 mm mini stereo jack
Impedance	>10k ohms unbalanced, DC coupled
Nominal level	-10 dBV (316 mVrms)
Maximum level	+6 dBV, (unbalanced) at 1% THD+N

Audio output

Number/signal type..................... 1 stereo, balanced/unbalanced

Connectors

Extender WM, Extender WM AUS, Extender WM AAP, Extender D

(1)3.5 mm direct insertion captive screw connector, 5 pole

Extender AAP, Extender AAP EX, Extender MK,

Extender AKM UK AAP, Extender WM AUS, Extender AKM MAAP


	(1) 3.5 mm captive screw connector, 5 pole
Impedance	50 ohms unbalanced, 100 ohms balanced
Extender Series • Specifications, Part Numbers, Accessories		A-3

Image 35

Contents VGA-UXGA Line Drivers With Audio Extender SeriesSafety Instructions English Precautions安全须知中文 Page Quick Start Guide Extender Series Power2‑12 Quick Start Guide - Extender Series, cont’dTable of Contents Table of Contents, cont’d Extender Series OneDifferences between the models IntroductionAbout this Manual About the Extender Series VGA Line DriversFeatures Introduction, cont’d Two UL Requirements InstallationInstallation Instructions Preparing the Site and Installing the Wall BoxPreliminary Preliminary Installation, cont’dSecuring the MK knockout box to a wall or furniture Installation, cont’d Front Panel Features and Cabling RGB video input connector PC Input Attach Extron Extender AKM Maap Top/Rear/Bottom panel Features and Cabling Audio output connector Insert wires into and tighten Extender WM is shown here wired for balanced Extender D gain switch location Preliminary Installation, cont’d Mounting the Extenders Mounting the Extender AAP EX to an HSA faceplate If the image does not appear or there is no sound Pre-installation testing/troubleshootingMounting the line driver to the wall box Mounting the Extender D to the wall box Mounting the Extender DMounting the Extender MK to the knockout box Application Diagrams AAppendix a Video input Specifications, Part Numbers, and AccessoriesSpecifications VideoAudio output SyncAudio Audio inputGeneral Specifications, Part Numbers, Accessories, cont’dExtender WM Faceplate X 2.8 W x 0.1 D EMI/EMC Ordering Information AccessoriesMounting accessories Mud rings/mounting brackets Part numbers CablesAppendixBB Extender AAP and Extender AAP EX dimensions Dimensions and TemplatesDimensions Extender WM dimensions Extender WM AAP dimensionsTemplates, cont’d Extender WM AUS dimensions Extender MK dimensions Dimensions and Templates, cont’dDetail a Extender AKM UK dimensionsExtender AKM Maap dimensions Extender D dimensions Extender WM template Extender WMExtender WM AAP template Extender WM AAPExtender MK template Extender MKExtender WM AUS template Extender WM AUSDimensions and Templates, cont’d Central America Extron’s WarrantyExtron Electronics, Europe Beeldschermweg 6C