Extron electronic RGB 103, RGB 112, RGB 109 user manual Cabling, Under desk mounting

Controls and Installation, cont’d

4.Using the four wood screws provided, attach the brackets under the mounting surface (see figure 10).

Figure 10 — Under desk mounting

To mount the interface through a desk or table using the through desk mounting kit (Extron part number 70-077-02), do the following:

1.Attach the mounting brackets to the interface using four machine screws and washers (supplied with the mounting kit), as indicated in figure 11.

I

UPN

T

M

ROTINEOFFUB

TUO DER

TUP COL

AL

				H
		M		HS.
		ICA	TFI
WEC		AFRETN
A/	BGR
PSDix301

4.Using the four wood screws provided, attach the brackets to the mounting surface, as shown in figure 12.

TUPNI

TUPLTACUOOLRDOTEIRNEOFMUB

		H
	M	HS.
	NICA	TFI
	RET
	ECAF
A/WBGR
PSDix3	01

Figure 12 — Through desk mounting

Cabling

Each interface can connect to the computer or workstation’s local monitor and to a projector or other display device.

Figures 13 through 15 show how to connect each of the interfaces.

1.Connect the local monitor’s video signal cable to the interface connector labeled “Buffered Local Monitor Output”.

Front

Rear

or

MFTA

Power

Audio

or

Figure 11 — Attaching the through desk brackets (part number 70-077-02)

2. Using the to-scale template on page B-4 to guide you,

mark the four screw holes on the underside of the

surface to which you are mounting the interface.

MAC Computer Monitor Projector

Figure 13 — RGB 103xi installation

Front

Rear

Use the through desk mounting template.

3. Drill four pilot holes, each 3/32” in diameter by 1/4”

Power

Audio

or

deep, where marked on the template.

PC Computer Monitor Projector

Figure 14 — RGB 109xi installation

2-10 RGB 103/109/112xi Controls and Installation RGB 103/109/112xi Controls and Installation 2RM-11