Installation and Operation, cont’d
4. | Repeat steps 2 and 3 on the other side of the YCS. |
5. | Hold the unit with the attached brackets against the |
| underside of the table or other furniture. On the mounting |
| surface, mark the location of the bracket’s screw holes. |
6. | Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm) |
| deep in the mounting surface at the marked screw |
| locations. |
7. | Insert #8 wood screws into the four pilot holes. Tighten |
| each screw into the mounting surface until slightly less |
| than 1/4" of the screw head protrudes. |
8. | Align the mounting screws with the slots in the brackets |
| and place the unit against the surface, with the screws |
| through the bracket slots. |
9. | Slide the unit slightly forward or back, then tighten all four |
| screws to secure it in place. |
Projector mounting using the PMK 450
The Extron PMK 450
Top Plate (1)
Pipe Collar (1) and
Set Screws (4)
AC Power Cord
Access Slot
Front Plate (1)
Security Screw (2) | Rear Plate (1) |
|
Extron
YCS SW2 A
Transcoding
Switcher
Bottom Plate (1)
Filler Plate (1)
Figure 2-7 — Components of the Extron PMK 450 kit
Two tools are included with the PMK 450 kit:
•A
•A security screw hex wrench
To
1.Unscrew the front and rear plates and the security screws from the sides of the PMK 450.
2. | Slide the top and bottom plates apart. |
3. | Loosen the four pipe collar set screws to allow the top |
| plate to move freely along the pole. |
4. | Ensure that the mounting pipe is installed with the cable |
| access hole facing the rear, away from the projector screen. |
5. | Slide the top plate up the pipe until the pipe collar is |
| positioned just above the cable access hole. Ensure the rear |
| of the top plate is facing to the rear, in the same direction as |
| the cable access hole in the pipe. |
Pipe Collar and
Set Screws
FRONT
REAR
Figure 2-8 — Positioning the top plate on the pipe
6. | Level the top plate and secure it by fully tightening the set |
| screws. At least three screws must come in contact with |
| the pipe. |
7. | Route the cables for the devices to be mounted so that the |
| cables exit the pipe through the cable access hole. |
YCS SW2 A • Installation and Operation |