Extron electronic DAS101CM Series, and DAV-DAS interconnection, DAS101CM’s 12 VDC Out port see

	connect the power supply to a DAS101CM module’s 12 VDC
	In port and loop the power through to the DAV101CM via the
	DAS101CM’s 12 VDC Out port (see page 2-6).
	N Do not tin the stripped power supply leads before
	installing the captive screw connector.
	C Correct polarity is important! The power wires must
	be attached to the correct terminals or the module can
	be damaged.
B	15-pin HD computer-video output (DAV101CM-1,-2,-5) —
	Attach this connector to the display’s 15-pin HD input
	connector.
C	BNC computer-video output (DAV101CM-3, -4, -6) — Attach
	these five male BNC connectors to the display’s BNC input
	connectors.

DAS101CM Series, and DAV-DAS interconnection

DAS101CM-1, -2, -5

Top View

12VDC
0.1 A
1	2	3

DAS101CM-3, -4, -6
Top
View
12VDC
0.1 A
1	2	3

	DAS101CM-1, -2, -5 Rear View	DAS101CM-3, -4, -6 Rear View
A	12 VDC, 0.1 A In (power input) — Connect a 12VDC, 1 A power
	supply to these two poles of the DAS’s 4-pole direct insertion
	captive screw connector for power input.
	C Correct polarity is important! The power wires must
	be attached to the correct terminals or the module can
	be damaged.
B	12 VDC, 0.1 A Out (power loop-through for DAV101CM
	modules) — This port allows power to be looped through to a
	DAV101CM. See the wiring diagram on the next page.
DAV101CM, DAS101CM • Installation and Operation			2-5