Extron electronic manual Mounting the PMK 350 to the Projector Pole

Extron PMK 350 Installation Guide

The PMK 350 Low Profile Multi-product Projector Mounting Kit is an above- projector mounting kit that can hold multiple products of 1/8, 1/4, and 1/2 rack sizes, and their power supplies. Each kit consists of a steel mounting tray that is available in black (part #70-563-02) or white (part #70-563-03); a U-bolt with a contoured brace bracket and an L bracket to secure the PMK to the projector pole; and a plastic, adhesive-backed overlay sheet (either black or white), containing four sizes of covers that can be torn out from the perforated sheet and applied over the opening on the bottom of the mounting tray.

The PMK 350 attaches to a 1.5" to 2" diameter projector mounting pole. Its low 2" height allows it to be mounted in tight spaces between the projector and the ceiling, while its width of 13.6" and depth of 11.5" enable it to accommodate a variety of device sizes.

	Extron
Rear Plate	Quarter-rack
	Sized Product

	Contoured
	Base
	L-shaped
	Bracket
Extron	U-bolt
PMK 350

Multi-product Projector

Mounting Kit

Extron

Power Supply

Front Plate

Cover Sheet

Mounting a quarter-rack sized product and its power supply

Mounting the PMK 350 to the Projector Pole

Mount products on the PMK 350 as follows:

1.	Remove the front and back panels from the PMK 350, using a #2 Philips
	screwdriver. Retain the four screws to reattach the plates when you are
	finished.
2.	Remove any rubber feet from the bottom of the device(s) to be mounted.
3.	Secure a device to one side of the mounting tray, using two of the supplied
	4-40 x 3/16" screws in opposite (diagonal) corners. Use an Extron Tweeker
	(provided) or a Philips #1 screwdriver to tighten the screws.
4.	If a power supply is connected to the device, use the two included cable tie
	wraps to strap the power supply to the bracket; or attach additional device(s),
	as described in step 3.
5.	Place the PMK 350 around the projector ceiling mounting pole. (See the
	illustration, above.)

68-1242-01, Rev A

07 06

PRELIMINARY

PMK 350 Projector Mounting Kit • Installation Guide