Gigabyte GA-8GEM667 manual English, FPANEL 2x10 pins connector, FAUDIO Front Audio Connector

9 ) F_PANEL (2x10 pins connector)

	MSG+	MSG-	PW+	PW-	SPK+	SPK-
2 1				1	1	20
1				1		19
	1
	HD+	HD-	RES-	RES+	N C
HD (IDE Hard Disk Active LED)				Pin 1: LED anode(+)
(Blue)				Pin 2: LED cathode(-)
SPK (Speaker Connector)				Pin 1: VCC(+)
(Amber)				Pin 2- Pin 3: NC
				Pin 4: Data(-)
RES (Reset Switch)				Open: Normal Operation
(Green)				Close: Reset Hardware System
PW (Soft Power Connector)				Open: Normal Operation
(Red)				Close: Power On/Off
MSG(Message LED/Power/				Pin 1: LED anode(+)
Sleep LED)(Yellow)				Pin 2: LED cathode(-)
NC( Purple)				N C

ØPlease connect the power LED, PC speaker, reset switch and power switch etc of your chassis front panel to the F_PANEL connector according to the pin assignment above.

English

10) F_AUDIO (Front Audio Connector)

Ø If you want to use "Front Audio" connector,

you must remove 5-6, 9-10 Jumper. In order to

10 9

Rear Audio (L)

Rear Audio (R)

POWER

GND

2 1

Front Audio (L)

Reserved

Front Audio (R)

REF

MIC

utilize the front audio header, yourchassis must

have front audio connector. Also please make

sure the pin assigment on the cable is the same

as the pin assigment on the MB header. To find

out if the chassis you are buying support front

audio connector, please contact your dealer.

11) SUR_CEN	Ø Please contact your nearest dealer for optional
	SUR_CEN cable.
BASS_OUT	CENTER_OUT
	GND
SUR OUTR	SUR OUTL
	1

- 19 - Hardware Installation Process