Gigabyte GN-AP101B manual

Page 31

nPoint To MultiPoint Mode

In this WDS supported mode, the Access Point can communication with other GIGA-BYTE Access point which is also set to Point to Point and MultiPoint mode.

Click the “WDS List”button, it will go to the WDS List page.

In this page, if you choose the "Automatic WDS", the Access Point will allow not only the MAC Address of the Access Points in the WDS List, but also the other Access Points that we have detected to communicate in this mode.

If you don't choose "Automatic WDS", the Access Point will only allow the Access Points which on the WDS List to communicate in this mode.

26

Image 31

Contents GN-AP101B Page European Community Directive Conformance Statement Federal Communications Commission FCC StatementFCC Radiation Exposure Statement Contents Introduction Contents of Your ShipmentPhysical Interface Access Point LED IndicatorsSpecifications Key featuresFeature Value Installation Static IP address Method Obtain IP Address Automatically Dhcp Server Enabled Installing the Access Point Manager Access Point ManagerClick Next Type the User Information then click Next Page Click Next Please wait a while Click Finishto complete setup Using the Access Point Manager Menu bar System Reboot and Load DefaultTool bar System Page IP Config Wireless Operation Page Encryption Page Page Radius Advanced OperationMode Page Page Associated List Set Community String Change AP Manager PasswordGigabyte AP Manager Utility \ Gigabyte AP Upgrade Upgrade FirmwarePage Click Yes Uninstall AP Manager UtilityPage Year Warranty Limited WarrantyCustomer Satisfaction