Gigabyte GA-K8NE user manual Troubleshooting, AMI Bios Beep Codes

Page 75

4-2 Troubleshooting

Below is a collection of general asked questions. To check general asked questions based on a specific motherboard model, please log on to http://www.gigabyte.com.tw

Question 1: I cannot see some options that were included in previous BIOS after updating BIOS. Why?

Answer: Some advanced options are hidden in new BIOS version. Please press Ctrl and F1 keys after entering BIOS menu and you will be able to see these options.

Questions 2: Why is the light of my keyboard/optical mouse still on after computer shuts down?

Answer: In some boards, a small amount of electricity is kept on standby after computer shuts down and that's why the light is still on.

Question 3: How do I clear CMOS?

Answer: If your board has a Clear CMOS jumper, please refer to the Clear CMOS steps in the manual. If your board doesn't have such jumper, you can take off the on-board battery to leak voltage to clear CMOS. Please refer to the steps below:

Steps:

1.Turn off power.

2.Disconnect the power cord from MB.

3.Take out the battery gently and put it aside for about 10 minutes (Or you can use a metal object to connect the positive and negative pins in the battery holder to makethem short for one minute).

4.Re-insert the battery to the battery holder.

5.Connect power cord to MB again and turn on power.

6.Press Del to enter BIOS and load Fail-Safe Defaults(or load Optimized Defaults).

7.Save changes and reboot the system.

Question 4: Why do I still get a weak sound after turning up the speaker to the maximum volume?

Answer: Please make sure the speaker you are using is equipped with an internal amplifier. If not, please change another speaker with power/amplifier and try again later.

Question 5: Sometimes I hear different continuous beeps from computer after system boots up. What do these beeps usually stand for?

Answer: The beep codes below may help you identify the possible computer problems. However, they are only for reference purposes. The situations might differ from case to case.

English

AMI BIOS Beep Codes

*Computer gives 1 short beep when system boots successfully. *Except for beep code 8, these codes are always fatal.

1 beep Refresh failure

2 beeps Parity error

3 beeps Base 64K memory failure

4 beeps Timer not operational

5 beeps Processor error

6 beeps 8042 - gate A20 failure

7 beeps Processor exception interrupt error

8 beeps Display memory read/write failure

9 beeps ROM checksum error

10 beeps CMOS shutdown register read/write error

11 beeps Cache memory bad

AWARD BIOS Beep Codes

1 short: System boots successfully

2 short: CMOS setting error

1 long 1 short: DRAM or M/B error

1 long 2 short: Monitor or display card error

1 long 3 short: Keyboard error

1 long 9 short: BIOS ROM error

Continuous long beeps: DRAM error

Continuous short beeps: Power error

- 75 -

Appendix

Image 75
Contents GA-K8NE Motherboard Product Manual Classification CopyrightTable of Contents Drivers Installation GA-K8NE Motherboard Layout Block Diagram Page Preparing Your Computer Considerations Prior to InstallationInstallation Notices Instances of Non-WarrantyALC850 Codec UAJ Feature SummaryUse of licensed Award Bios Installation of the CPU Installation of the CPU and HeatsinkInstallation of the Heatsink Installation of MemoryDDR1 DDR2 DDR3 Installation of Expansion Cards I/O Back Panel Introduction Side Speaker Out Connectors IntroductionATX12V / ATX Power Connector FDD FDD Connector Cpufan / Sysfan Cooler Fan Power ConnectorSATAII01 / SATAII23 Serial ATA Connector IDE1 / IDE2 IDE ConnectorFpanel Front Panel Jumper Pwrled Faudio Front Audio Panel ConnectorUSB1 / FUSB2 / FUSB3 Front USB Connector Cdin CD In ConnectorCI Chassis Intrusion, Case Open Comb Comb ConnectorClrcmos Clear Cmos BAT BatteryEnglish Main Menu Status Page Setup Menu / Option Page Setup MenuMain Menu For example Bios Ver. F1b „ Exit Without Saving „ Set Supervisor Password„ Set User Password „ Save & Exit SetupTime IDE Channel 0 Master, Slave, IDE Channel 1 Master, SlaveIDE Channel 2/3/4/5 Master Floppy 3 Mode Support for Japan Area Drive a / Drive BHalt on Hard Disk Boot Priority First / Second / Third Boot DeviceBoot Up Floppy Seek Init Display First Password CheckOn-Chip IDE Channel1 IDE DMA transfer accessIntegrated Peripherals On-Chip IDE Channel0IDE Primary Master RAID IDE Prefetch ModeOn-Chip MAC Lan NV IDE/SATA RAID functionAC97 Audio Parallel Port ModeECP Mode Use DMA USB Memory TypeModem Ring On Legacy DOS USB MouseLegacy USB Storage detect PME Event Wake UpKB Power on Function Power-On by AlarmPower On By Mouse Power On By KeyboardPnP/PCI Configurations DDR25V PC Health StatusCase Opened Reset Case Open StatusCurrent CPU Temperature CPU Warning TemperatureTemp Limit of High Speed Default temperature 60oC Temp of FAN turn off Default temperature 0oCTemp Limit of Low Speed Default temperature 20oC Temp Limit of Mid Speed Default temperature 50oCPcie Clock CPU FrequencyK8 CPU Clock Ratio CPU Spread SpectrumTop Performance Set Supervisor/User Password Exit Without Saving Save & Exit SetupInstall Chipset Drivers Drivers InstallationSoftware Information Software ApplicationContact Us Hardware InformationEnglish Unique Software Utilities User Interface Overview EasyTune 5 IntroductionXpress Recovery Introduction What is Xpress Recovery ?How to use the Xpress Recovery English F9 For Xpress RecoveryExit and Restart Remove Backup Image  Remove backup image. Are you sure? Y/NFlash Bios Method Introduction Method 1 Q-FlashTMUtilityBefore You Begin Task menu for Q-Flash utility Exploring the Q-FlashTM / Dual Bios utility screenTask menu for Dual Bios utility Entering the Q-FlashTMutilitySteps Using the Q-FlashTMutilityYou can repeat to Part Two FlashTMutility bar Exploring the Q-FlashTMutility screenCongratulation!! You have updated Bios successfully Methods and steps Method 2 @BIOSTM UtilityEnglish RAID Levels Serial ATA Bios Setting Utility IntroductionEntering the RAID Bios Setup Configuring the Nvidia RAID BiosAssigning the Disks Using the Define a New Array WindowSelecting the RAID Mode Selecting the Striping Block SizeYES Completing the RAID Bios SetupArray 2 Nvidia Mirror 76.33G Cd bootdrv Menu Installing the RAID driversIntroduction of audio connectors Stereo Speakers Connection and Settings5 2- / 4- / 6- / 8- Channel Audio Function Introduction Channel Audio Setup English Step AMI Bios Beep Codes TroubleshootingEnglish English English Taiwan Headquarters Contact UsChina Shanghai
Related manuals
Manual 80 pages 41.89 Kb

GA-K8NE specifications

The Gigabyte GA-K8NE is a motherboard that stands out in the realm of Socket 754-based systems, catering primarily to AMD's Athlon 64 and Sempron processors. Renowned for its stability and reliability, the GA-K8NE is ideal for users seeking to build a budget-friendly yet robust computing solution.

One of the main features of the GA-K8NE is its support for single-channel DDR400 memory, accommodating up to 2GB of RAM. This allows for decent multitasking capabilities, making it suitable for various applications from basic computing tasks to more demanding multimedia processing. The motherboard features two DIMM slots, ensuring flexibility in memory upgrades.

In terms of connectivity, the GA-K8NE is equipped with an array of PCI slots, including a PCI Express x16 slot for dedicated graphics cards. The inclusion of a Gigabit Ethernet controller enables high-speed internet access, essential for both gaming and media streaming. Additionally, users can take advantage of multiple USB 2.0 ports for peripheral connectivity, enhancing overall usability.

The GA-K8NE also includes a variety of storage options, featuring four SATA connectors for modern hard drives along with PATA options for legacy devices. This versatility ensures that users can integrate both contemporary and older storage technologies seamlessly.

When it comes to audio, the motherboard is integrated with Realtek's ALC655 chipset, providing 6-channel audio output. This feature enriches the multimedia experience, making it suitable for home theater setups or gaming applications where sound quality is paramount.

Another notable technology included in the GA-K8NE is Gigabyte's patented DualBIOS technology, which provides an extra layer of security against BIOS failures. Should a primary BIOS be corrupted, the backup BIOS can auto-recover, ensuring reliable system operation and peace of mind for users.

With its balance of performance, capacity for upgradeability, and key features like robust audio and solid networking capabilities, the Gigabyte GA-K8NE remains a commendable choice for budget-conscious users looking to build a capable home or office PC. Its combination of technological advancements and practical features makes it a noteworthy option in the competitive motherboard market.