3
Installation (Continued)
Step 3:
Connect the end of the cable with the right angle DIN connector and audio cables to the back of the head unit as shown in Figure 2. The shorter end of the cable coming from the PIA is a
Left/Right Audio | Connector |
| |
Cables(ModelSpecific) |
|
Figure 2. Typical Head Unit, Rear View
Note: The location of the connections on the head unit may vary depending on the model.
Step 4:
Start your car and turn on your head unit to confirm that the XM Direct system is properly connected. Please refer to your stereo owners manual on how to access XM mode. When you tune to XM channel 1, you should see “XM Preview” on your head unit LCD, and hear that channel through your car speakers. If not, check to make sure all connections are correct or refer to the troubleshooting section of this installation guide.
Step 5:
Mount and secure the interface cable in a suitable location that will not interfere with the radio and will not vibrate or rattle after installation.