Philips AZ1133 user manual English, Power Supply General Operation/Tuner

English Controls/Power Supply

Power Supply General Operation/Tuner

Congratulations on your purchase and welcome to Philips!

To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome.

Supplied Accessories

– AC power cord

Top/front panels (See 1)

1Source selector: CD/MP3, FM, MW or

OFF

–selects CD/MP3, FM or MW source of sound

–power off switch

22 ; – starts or pauses CD/MP3 playback

§ ∞

–selects the next/previous track

–fast searches forwards/backwards (press and hold the button)

PROG – programs tracks

9– stops CD playback;

– erases a CD program

3Display – shows the CD functions

4MODE – selects different play modes:

e.g. REPEAT or SHUFFLE (random order)

5ALBUM + – For MP3-CD only: selects albums

6OPEN•CLOSE – opens/ closes the CD door

7TUNING – tunes to radio stations

8VOLUME – adjusts volume level

Back/bottom panels (See 1)

9Telescopic antenna – improves FM reception

0Battery door – open to insert 6 x 1.5V R-14/UM-2/C-cells

!p – 3.5 mm stereo headphone socket Helpful hints: The speakers will be muted when headphones are connected to the set.

@AC MAINS~ – inlet for power cord

CAUTION

Use of controls or adjustments or performance of procedures other than herein may result in unsafe operation.

This set complies with the radio interference requirements of the European Union.

Power Supply

Whenever convenient, use the power supply cord if you want to conserve battery life. Make sure you remove the plug from the set and wall outlet before inserting batteries.

Batteries

1Insert 6 batteries, type R-14, UM2 or C- cells (not included, preferably alkaline) with the correct polarity. (See 1).

2Replace the battery door, making sure the bat- teries are firmly and correctly in place.The set is now ready to operate.

•Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst:

•Do not mix battery types: e.g. alkaline with car- bon zinc. Only use batteries of the same type for the set.

•When inserting new batteries, do not try to mix old batteries with the new ones.

•Remove the batteries if the set is not to be used for a long time.

Batteries contain chemical substances, so they should be disposed of properly.

Using AC power WARNING:Always check you have completely switched off the set, before you change or disconnect power supply.

1Check if the power voltage, as shown on the type plate located on the bottom of the set, corresponds to your local power supply. If it does not, consult your dealer or service center.

2Connect the power cord to the

AC MAINS~ inlet and the wall socket.The set is now connected and ready for use.

3To switch the set off completely, withdraw the power cord from the wall socket.

4Install the unit near the AC outlet and where the AC power plug can be easily reached.

•Disconnect the power cord from the wall socket to protect your set during heavy thun- derstorms. Children could seriously injure themselves as the free end of the cable may still be live if only the connector is removed from the MAINS socket at the back of the unit.

The type plate is located on the bottom of the set.

Helpful hints:

–To avoid unnecessary energy consumption, always adjust the Source selector to OFF after using the set.

General operation

Switching on and off and selecting the function

1To select your sound source, adjust the Source selector to: CD/MP3, FM, or MW.

2To switch off the set, adjust the Source selector to OFF position.

Adjusting volume

Adjust the sound with the VOLUME control.

Radio reception

1Adjust the Source selector to FM or MW to select your desired waveband.

2Turn TUNING to tune to a station.

Helpful hints:

To improve radio reception

•For FM, extend, incline and turn the telescop- ic antenna for best reception. Reduce its length if the signal is too strong.

•For MW, the set uses a built-in antenna. Direct this antenna for best reception by turning the whole set.