Unpacking and Overview
D1 – D5: Refers to Device 1 - 5
Power LED
|
|
|
|
| Host |
| SET | Power | USB 3.0 | LED | |
|
| ||||
eSATA Device Port | Button | input |
| to host eSATA | |
| Dipswitch (SW1) | Power | Host | ||
|
| ||||
| on/off |
| |||
|
|
|
| ||
Drive Activity LED:
LED will light up. If the drive is being accessed, the green LED will blink.
eSATA Ports:This is where you connect your eSATA devices (like your eSATA drive enclosure)
Power input: Connects to 5V Power supply or USB power cable.
Power on/off: This turns the port multiplier ON or OFF. When the power switch is in the OFF position, the port multiplier will be powered by a USB host, if connected. When the power switch is in the ON position, the port multiplier will be powered by the power input.
eSATA Host: Connects to eSATA controller card on a computer.
USB 3.0 Host: Connects to USB 2.0 or 3.0 port on a computer.
NOTE: Do not connect USB and eSATA at the same time.
Host LED: Glows to indicate an active connection from USB or eSATA to a host adapter, blinks to indicate activity.
Dipswitch and SET Button: Used to control the Port Multiplier RAID Mode setting.
Power Supply
USB Power Cable | Driver Disk |
www.addonics.com
Technical Support | Phone: | Email: www.addonics.com/support/query/ |