Addonics Technologies ST55HPMXA manual Removing Cover of Storage Tower, Step

Page 2

Screws

Removing Cover of Storage

Tower V

Loosen the 3 screws at the back of the tower using a Philips screwdriver by turning counter-clockwise. Separate the metal casing of the tower from the housing by lifting up the casing.

Installing drives into the

Storage Tower

Step 1

Screw the hard drives into the optional mounting brackets or slide in 5.25” devices into the tower. Other types of enclosures like the 5SA disk array can also be mounted. Mounting one 5SA disk array and another one 3SA disk array allows you to mount a maximum of 8 SATA drives.

Step 2

Using 3.5” SATA Hard Disk Drives Connect the internal SATA data cable to the data port of the hard drive then connect the 15-pin SATA power connector to the power port on the hard drive.

Hard Disk

Step 3

Secure the hard disk by using screws provided. Repeat the above procedure for additional hard drives.

www.addonics.com

Technical Support (M-F 8:30am - 6:00pm PST)

Phone: 408-453-6212

Email: www.addonics.com/support/query/

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Technical Support Hours 830 am 600 pm PST PhoneStep Installing drives into Storage TowerRemoving Cover of Storage Tower Dip Switch Settings LED Pin Header Default factory DIP Switch settingError LED Activity LEDBZS EZ M2 M1 M0SW1 RAID Setting Notes Which port acts as a spare drive? Power on/off controlWhen will rebuild action start?
Top Page Image Contents