BenQ FP937s user manual How to choose the right Refresh Rate

Page 16

6How to choose the right Refresh Rate

You don't have to choose the highest possible refresh rate on an LCD display, because it is not technically possible for an LCD display to flicker. The best results are obtained by using the factory modes already set in your computer. There is a table with the factory modes in this user’s guide. Youc an choose 60, 70 and 75 Hertz, (but not 72Hz) for the native resolution of 1280x1024. In Windows 98/2000/ME/XP you can change the refresh rate as follows:

1. Double click the “Display” icon in the Control Panel.

16How to choose the right Refresh Rate

Image 16

Contents Welcome Iv Care And Cleaning CopyrightIi Disclaimer ServicingTable of Contents Page Getting started Getting to know your Monitor Back View 2 Locations of plugs & sockets How to install your monitor hardware How to install your monitor hardware How to install your monitor’s software How to install your monitor’s software Choose Monitor from the list and then click Next Windows XP Choosing the best picture resolution Choosing the best picture resolution How to choose the right Refresh Rate How to choose the right Refresh Rate How to choose the right Refresh Rate How to set the Picture Optimization How to adjust your Monitor Brightness and Contrast hot keyMain Menu Mode Geometry sub menu Color sub menu OSD sub menu Languages Sub menu Recall sub menu Miscellaneous sub menu Troubleshooting Frequently Asked Questions FAQNeed More Help? Incoming display mode Input timing Supported operating modesSpecifications Model FP937sSpecifications BenQ FP937+ Model FP937s+Specifications