Unit Functions
Listening to the Radio
A B C D E
F
G
H
I
J
K
L
PO
M
N
G
H
J | U |
V
E 
C
1
2
3
1Press the FUNCTION button to select “TUNER”.
<You can also use the FM/AM button to select “TUNER”.
2Press the FM/AM button to select a band.
3Select the station you want to listen to (auto selection).
Hold down the TUNING Up or Down button until the frequency display begins to change. When a station is tuned in, the tuning process will stop automatically.
<Press the Up or Down button to stop the auto selection.
FM MODE button
Pressing this button alternates between STEREO mode and MONO mode.
STEREO
FM stereo broadcasts are received in stereo and the “STEREO” indicator lights in the display.
<If the sound is distorted and the “STEREO” indicator flashes, the signal is not strong enough for good stereo reception. In this case, change to MONO mode.
MONO
To compensate for weak FM stereo reception, select this mode. Reception will now be forced to monaural, reducing unwanted noise.
If the reception is poor
AM broadcast
Rotate or relocate the AM antenna to find the best position for AM stations.
FM broadcast
Extend and rotate the FM antenna until you receive the stations clearly. You may need to relocate the unit.
Q
D
Selecting stations which cannot be tuned automatically
W
R
A
B
L
S
T
M
K | Note: |
XTo simplify explanations, instructions in this manual refer to
the names of the buttons and controls on the front panel only. Associated controls on the remote control will also operate similarly.
(manual selection)
When the Up or Down button is pressed momentarily, the frequency changes by a fixed step.
Press the Up or Down button repeatedly until the station you want to listen to is found.
10 | 23 |