Tripp Lite B132-100-WP owner manual Installation, B132-100 B132-100WP B132-004 Local Unit

Installation

B132-100

B132-100WP

B132-004 Local Unit

Note: Test to make sure the entire installation works properly before pulling cables through ceilings/walls.

1Follow the instructions that come with the B132-004 Local Unit before connecting the B132-100 Remote Unit or B132-100-WP Wallplate.

2For the B132-100:Use Cat5e/6 cable to connect one of the Output ports on the B132-004 Local Unit to the Input port on the B132-100 Remote Unit.

3For the B132-100-WP:Use the included 110 Punchdown tool to connect each of the colored wires inside the Cat5e/6 cable to the corresponding areas of the 110 Punchdown connector, and then connect the other end of the Cat5e/6 cable to an Output port on the B132-004 Local Unit.

4Connect a monitor to the Output port of the B132-100 Remote Unit or B132-100-WP Wallplate using a Tripp Lite P502-Series VGA cable.

5First turn on the monitor, and then turn on the computer connected to the B132-004’s Source port. If your picture is too dark, or is displaying a “ghosting effect,” use the screwdriver included with the B132-100 to adjust the Equalization and Gain controls.

4