Important Safety Instructions

•Do not use with life support appliances if a malfunction or failure could cause failure or significantly alter the performance of the life-support device. Do not use in the presence of a flammable anaesthetic mixture with air, oxygen or nitrous oxide.

•Install your surge suppressor indoors, away from excess moisture, heat and dust.

•Connect your surge suppressor to a three-wire, grounded AC power outlet. Do not remove or modify the ground pin of the surge suppressor's plug. Do not use two-prong adapters with the surge suppressor's plug.

•Your surge suppressor does not require maintenance. Do not open your surge suppressor for any reason. There are no user-serviceable parts inside.

Quick Installation

1Plug surge suppressor into a three-wire, grounded 120V

electrical outlet.

The surge suppressor cannot provide full protection unless it is plugged into a properly wired and grounded outlet. The ISOBAR6ULTRAHG features a hospital grade plug and outlets. Grounding reliability can only be achieved when the ISOBAR6ULTRAHG is connected to an equivalent grounded receptacle marked "Hospital-Only" or "Hospital-Grade."

2Flip surge suppressor's ON - OFF switch ON (switch will

light up.)

When this switch is lit, it indicates that AC power is enabled at the surge suppressor's outlets.

3Plug the power cords of your electrical equipment into your

surge suppressor's outlets.

Your electrical equipment is now protected from AC surges on the power line.