Tripp Lite SK30USB, SK120USB owner manual Important Safety Instructions, Installation

Page 2

Important Safety Instructions

SAVE THESE INSTRUCTIONS

CAUTION! DO NOT connect to an ungrounded outlet. DO NOT use with 2-wire extension cords or adapters. This surge suppressor is designed for indoor use only. Install the surge suppressor away from heat-emitting appliances such as radiators or heat registers. Do not install where excessive moisture is present. Do not plug extension cords into it. Never install electrical, telephone, network or coaxial wiring during a lightning storm. Do not drill into any part of the housing or open the housing for any reason. There are no user-serviceable parts inside.

Use of this equipment in life support applications where failure of this equipment can reasonably be expected to cause the failure of the life support equipment or to significantly affect its safety or effectiveness is not recommended. Do not use this equipment in the presence of a flammable anesthetic mixture with air, oxygen or nitrous oxide.

Installation

Connect Your Surge Suppressor to the AC Power Line: Plug the surge suppressor directly into a 3-wire grounded, 120V AC outlet.

Secure Surge Suppressor to Outlet Using Included Mounting Screw (SK30USB only): Securing the surge suppressor to the outlet will prevent accidental disconnection. Remove the wall outlet cover plate and plug in surge suppressor. Screw in the included mounting screw to attach the surge suppressor to the outlet.

Check Your Surge Suppressor’s Diagnostic Indicator Lights: If your surge suppressor features diagnostic LEDs or indicators, check them prior to connecting your equipment. They will indicate various operating conditions when the surge suppressor is plugged into a live 120V AC outlet and the surge suppressor’s power switch is on.

“PROTECTED” LED: Indicates the surge suppression components are intact and providing complete protection against surges. If this LED does not illuminate, some of the surge suppression components are not functioning, and the unit should be replaced. Visit www.tripplite.com/support.

Connect Your Equipment to the Surge Suppressor’s AC Outlets: Plug your equipment’s power cords (including 2-wire devices) into the surge suppressor’s AC outlets. Select models feature integrated safety covers which cover the outlets when not in use. Other models feature special widely-spaced outlets to accommodate transformers without covering other outlets. DO NOT plug in extension cords. DO NOT OVERLOAD the surge suppressor’s outlets. The surge suppressor can accommodate a total equipment load of up to 15 amps (whether plugged into a single outlet or spread out over multiple outlets).

USB Charging Ports: Two USB charging ports are capable of delivering up to 2.1 A total. This will provide enough power to charge the most demanding devices, including smartphones, tablets and MP3 players.

 

2

13-05-275 93-32C1-EN.indd 2

6/14/2013 9:23:41 AM

Image 2
Contents Protect It! Wall-Mount Important Safety Instructions InstallationLifetime Limited Warranty Warranty RegistrationUltimate Lifetime Insurance Policy