4. Installation
4.7 Multiple Station (Cascaded) Installation
The
4.8 Hot Plugging
All KVM switches support hot
Switching Station Positions
Switch station positions by simply unplugging the
Hot Plugging CPU Ports
Switch CPU ports by unplugging the KVM cable kit and replugging into the desired port. In order for the OSD menus to correspond to the change made, you must manually reconfigure the OSD information for the new port. See the F3 SET (page 15) and F4 ADM (page 16), functions for details.
Note: If the computer’s Operating System does not support hot plugging, this function may not work properly.
Hot Plugging Console Ports
Keyboard, monitor, and mouse can all be hot plugged. When hot plugging the mouse:
1.You may unplug the mouse and plug it back in again (to reset the mouse, for example), as long as you use the same mouse.
2.If you plug in a different mouse, all the stations and all the computers on the installation must be shut down for 10 seconds, then restarted using the Power Up Sequence described on page 8.
5.Basic Operation
5.1 Opening the NetDirector Console KVM
The console is located under the top cover. To access the console, slide the console module out and raise the cover.
Note: As a safety precaution, to keep the console from accidentally sliding out, the console is locked into the in position. Before you can pull the console module out, you must release it by pushing the catches on the unit’s front panel toward the center of the switch.
5.2 Closing the NetDirector Console KVM
To slide the console module back in, close the cover and do the following:
1.Pull the safety catches on the unit’s side rails toward you and push the module in until it stops.
2.Release the catches; pull the module slightly toward you; then push it all the way in.
Note: The reason for the
9
201011080 • | 11/29/2010 4:30:13 PM |