Instruction Manual
7.Insert the circuit board (removed in step #3) into the enclosure by aligning the USB connector (provided by the circuit board) with the USB port (provided by the frame), and gently applying pressure to the bottom of the circuit board until it is locked in place:
8.Connect the CE IDE (zif) cable to the drive, such that the label of the hard drive is facing upward***.
***Please note:
IDE1810U2Z is
9.Once the drive is connected, situate it in the enclosure so that the label is now facing into the enclosure:
10.Place the front panel over the drive, by situating the bottom of the panel inside the enclosure, then securing the remainder:
10. Replace the screw that was removed in step #1.
4