Installation
WARNING: Hard drives require careful handling, especially when being transported. If you are not careful with your hard disk, lost data may result. Always handle your hard drive and storage device with caution.
Hardware Installation
1. Remove the small screw from the rear panel of the enclosure.
|
|
|
|
|
|
| Power/Activity LED | |
|
|
|
|
|
|
| ||
USB |
|
|
|
|
|
| Rear Panel screw | |
|
|
|
|
|
| |||
|
|
|
|
|
|
|
| |
connector |
|
|
|
|
|
|
| Screw Driver |
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| (included) |
2. Open the top panel of the enclosure by pulling the plastic pull tab.
Pull Tab
3.If using a 5mm drive, place the two foam pads on the bottom of the drive tray. The foam pads are not required if using an 8mm drive.
Foam Pads
Instruction Manual | 2 |