StarTech.com ST100SLP instruction manual Introduction, Features

Page 4

Instruction Manual

Introduction

Thank you for purchasing a StarTech.com 10/100 Mbits/sec PCI Ethernet card. Featuring Auto-Negotiation capability and support for data transmission bandwidth from 10Mbps to 100Mbps, the card is easy to install and set up, and is fully Plug and Play compatible in a wide range of operating environments.

Features

•Support for IEEE802.3x Full-Duplex flow control

•Capable of full and half-duplex communications

•Complies with industry standards: IEEE 802.3, 100BaseTX and 10BaseT standard

•Supports 32-bit PCI Bus Master for high performance and low processor utilization

System requirements:

•An IBM-compatible computer with a Pentium-based processor

•An available PCI slot

•One of the following operating environments: Windows Vista/XP/ME/2000/98/95, Windows NT, Linux, NetWare 3.x/4.x, Lan Manager, TCP/IP software

Package contents:

This package should contain:

•1 x PCI Ethernet Adapter card

•1 x Driver disk

•1 x Installation Guide

•1 x Full-size Bracket (ST100SLP only)

1

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Network Adapter FCC Compliance Statement Table of Contents Features IntroductionInstalling the Network Card Connecting Your Card to a NetworkInstalling the Drivers Verifying Driver InstallationTips for Setting Up Your Network Make sure your computers are configured properlyClick on Start, then Settings, then Control Panel Click Start, then Settings, then Control PanelMake sure all your computers are on the same workgroup Click Start and then Control PanelMake Sure Your Sharing is Set Up Properly Click on File and Print SharingSpecifications About StarTech.com
Top Page Image Contents