Note:You can adjust the horizontal and vertical position, contrast, and brightness to better suit your video card and your personal preference.
Before you begin, make sure that power to all of the devices you will be connecting to the console have been turned off. To prevent damage to your installation due to ground potential difference, make sure that all of the devices being installed are properly grounded. Once all peripherals have been connected, please power them on.
Panel controls and OSD functions
The following controls are located on the left side of the the console monitor:
Controls | Descriptions | |
| Soft power on/off. Adjacent LED is lit when on. | |
Auto | ||
preset timings. | ||
| ||
Up | Press to scroll to the function you want to adjust. | |
Down | Press to scroll to the function you want to adjust. | |
Menu | To access the main menu. This button also acts as the Enter | |
button. | ||
|
Auto tune
Press the “Auto tune” button. The panel will adjust the display size automatically and also tune the panel to its optimized state.
Input Source
1.Press the Menu button.
2.Use the Down and Up buttons to scroll.
3.Press the Menu button to enter, and you will see: VGA/DVI.
4.Use the Down and Up buttons to select the input signal source.
5.Press the Menu button to save your selection.
Instruction Manual
6