Troubleshooting
WARNING
Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, fi rst check the points listed below before taking the system for repair. If you are unable to solve a problem by following these instructions, consult your dealer or Philips for help.
Problem (General) |
| Solution |
No power. | – | Check if the AC power cord is properly connected. |
| – | Press the 2(STANDBY ON) on the front of the |
|
| DVD system to turn on the power. |
No picture. | – | Refer to your TV’s manual for correct Video In |
|
| channel selection. Change the TV channel until you |
|
| see the DVD screen. |
| – | Press the DISC button to select disc mode. |
| – If this happens when you are turning on the progressive | |
|
| scan feature, wait for 15 seconds for the auto recovery. |
Completely distorted picture | – | If this happens when you are changing the setting of the |
or black/white picture. |
| ‘TV TYPE’, wait for 15 seconds for the auto recovery. |
| – | Check the video connection. |
| – | Sometimes a small amount of picture distortion may |
|
| appear. This is not a malfunction. |
| – | Clean the disc. |
No sound or distorted sound. | – | Adjust the volume. |
| – | Check the speaker connections and settings. |
| – Make sure that the audio cables are connected and | |
|
| press the SOURCE button to select the correct input |
|
| source (for example, TV or AUX/DI) to choose the |
|
| device that you want to hear through the DVD system. |
There is no sound from the | – | Make sure that the centre and rear speakers are |
centre and rear speakers. |
| connected correctly. |
| – | Press the SURR. button to select a correct surround |
|
| sound setting. |
| – Make sure that the source you are playing is recorded or | |
|
| broadcast in surround sound (DTS, Dolby Digital, etc.). |
The remote control does not – Select the source you want to play (for example,
function properly.DISC or TUNER) beforepressing the function button (X, ./ >).
–Reduce the distance between the remote control and the system.
–Replace the batteries with new ones.
–Point the remote control directly toward the IR sensor.
–Check that the batteries are loaded correctly.
English
47