Pelco c2626M manual Illustrates the front panel of the SX8205R module

Page 8

FRONT PANEL

Figure 2 illustrates the front panel of the SX8205R module.

Figure 2. Front Panel of SX8205R Module

ìReset Button: Restarts the unit

îPower LED: Pelco badge

NOTE: For additional information about the Power LED, refer to Troubleshooting on page 15.

8	C2626M (2/07)

Image 8

Contents Ethernet Switch List of Tables ContentsList of Illustrations Important Safety Instructions Risk of Electric Shock Do not Open Regulatory Notices Radio and Television InterferenceProduct Overview DescriptionModels Rack mount chassisFront Panel of SX8205R Module Reset Button Restarts the unit Illustrates the front panel of the SX8205R moduleRear Panel Illustrates the rear panel of the SX8205R moduleInstallation Package ContentsAutonegotiation is enabled by default Flow control is disabled by defaultTable A. TX Mode Switch Settings Flow control default settingMounting Mounting the SX8205R Module Into a RackMounting the SX8205R Module Using the Wall Clip Connections 10BASE-T/100BASE-TX connectionsTroubleshooting Table C. Troubleshooting with Rear-Panel Indicators Desired, refer to SettingAmber 10BASE-T link is If 10BASE-T operation is Established 10 for informationSetting of the remote Not lit 10BASE-T orDo any of the following as 100BASE-TX link Cable Applicable Cannot beDuplex mode Duplex mode LinkIf half-duplex mode is Amber Port is set to If 10BASE-T full-duplexGreen Port is set to If 100BASE-TX full-duplex Flashing green Port is set to100BASE-TX half Replace cable if it isTable C. Troubleshooting with Rear-Panel Indicators Specifications Link/activity and speed, duplex/collision and speedAppendix. RJ-45 Connector Pinouts Illustrates RJ-45 MDI/MDI-X connector pinoutsProduct Warranty and Return Information ISO9001