Tuner Operations
E n g l i s h
IMPORTANT!
Make sure the FM and MW antennas are connected.
Tuning to radio stations
1Press SOURCE control to select “TUNER FM” or “TUNER MW”.
2Press 34 briefly on the remote.
➜"SEARCH" appears.
➜The next radio station will tune automatically.
3Repeat step 2 if necessary until you find the desired radio station.
4To tune a weak station, press S / T briefly and repeatedly until an optimal reception is found.
●If the FM station reception is weak, you can switch the FM mode from stereo to mono. Press SURR button will toggle through:
DOLBY PL II FM ST (stereo)
™DOLBY PL II FM MONO
™STEREO FM MONO
™STEREO FM ST
Presetting radio stations
You can store up to 20 FM and 10 MW preset radio stations in the memory.
Helpful Hints:
–The system will exit presetting mode if no button is pressed within 20 seconds.
–If no valid frequency is detected during Plug and Play," CHECK ANTENNA" appears.
Using the Plug and Play
Plug and Play allows you to store all available radio stations automatically.
AUTO INSTALL PRESS PLAY
21
1For first time setup, press SOURCE on front panel to select TUNER mode.
➜ "AUTO INSTALL PRESS PLAY" appears.
2Press 2; on the top panel to start installation.
➜"INSTALL TUNER" appears.
➜Once complete, the last tuned radio station will play.
➜FM followed by MW bands will be stored.
36
36 | 3139 115 23251 | |
13/08/2004, 11:25 AM |