Installation Instructions
UIM-10/100
Uplink Interface Module
CAUTION Net to Net Technologies strongly recommends the use of proper electrostatic discharge (ESD) precautions when handling this equipment.
INSTALLATION
1.Unpack and inspect the equipment.
The following components should be included:
!1
!4 #6 Phillips Panhead Internal Locking Screws
!2 #6 Phillips Beige Flathead Screws
If there is visible damage, do not attempt to connect the device; contact Customer Support at
2.Install the
Required tool for installation: Phillips screwdriver.
UIM Installation in an IP DSLAM
Affix the UIM to a Multiplexer Uplink Module (MUM).
NOTE The UIM may be attached to a MUM that has already been in service, although you must remove the MUM from the IP DSLAM in order to do so. Removal of a MUM from an IP DSLAM chassis that is
powered up will not affect the operational status of other modules within the chassis; it will, however, disengage the IP DSLAM's upstream network connection.
a.Place the MUM on a flat surface with the circuit board facing up.
b.Select a port on the MUM for UIM installation; either port (1 or 2) may be used. Although not required for operational purposes, if redundancy is desired, two UIMs may be installed on the MUM, one in each port.