Paradyne MUM200-2 installation instructions IP Dslam Management, Additional Information

Verify the connection: the Lnk (link) LED on the UIM-DS3 and UIM-E3 faceplate will flash green to indicate a network connection has been established.

For further information refer to the Installation Instructions for each individual UIM model.

2.0IP DSLAM MANAGEMENT

The MUM200-2 provides IP DSLAM management capability via Net to Net's web-based Network Management System (NMS) and a scaled-down version of Simple Network Management Protocol (SNMP). For access and configuration instructions, refer to Net to Net's NMS Management User Guide.

3.0ADDITIONAL INFORMATION

3.1LED Indications

LED	State	Indication	Additional Information
PWR	solid green	MUM200-2 is receiving	Both IP DSLAM power terminals are connected.
(Power)		power
	solid amber	MUM200-2 is receiving	One of the two IP DSLAM power terminals are
		power	connected.
	no	no power	The MUM200-2 is not receiving power (the IP
	illumination		DSLAM may not be receiving power either).
Fan	no	all fans are functioning	All four of the fans on the IP DSLAM fan card are
	illumination		functioning.
	solid amber	non-functioning fan	One or more of the four fans on the IP DSLAM fan
			card are no longer functioning.
Lnk (Link)	solid green	direct Ethernet	The Lnk LED applies only to direct physical
		management connection is	connections with the MGMT port; it does not
		established	apply to uplink network connections.
			The MGMT Ethernet port runs at 10 Mbps and
			Half Duplex.
	no	no direct connection via
	illumination	the MGMT port is
		established

UIM Lnk	solid green	UIM-10/100 Ethernet
(Link)		uplink connection is
		established
	flashing	UIM-T1/E1 or UIM-DS3/E3
	green	uplink connection is
		established
	no	no uplink connection is
	illumination	established

For further information regarding UIM-10/100 LEDs, please refer to the corresponding UIM Installation Instructions.

For further information regarding UIM-T1/E1 or UIM-DS3/E3 LEDs, please refer to the corresponding UIM Installation Instructions.

Applicable to all UIM models types.

220-0000069 rev 04