Removing the Existing Fan Tray Assembly
You will need a Phillips screwdriver to remove the vent cover and fan tray.
Procedure
To remove the existing fan tray assembly:
1.Remove three screws from the fan cover plate, and then remove the cover plate from the chassis, taking care not to damage the LED protruding through the cover plate.
2.Loosen (but do not remove) the two screws on each locking bracket, and use them to slide both locking
brackets toward the middle of the front panel until the ends clear the slots in the side plates.
D
O
NCA
UO
NTUTION!
UDEPL
S R
E A
TTC
HEHE
P E FIN
UDFA
LLESNGE
ARIGTRR
N AS
EASY
TE
D
Locking Bracket 
P
AREAULL
P
AULL
REA
POWER ALARMS
AB Fan Major Minor
CLOCK | SERIAL | AC |
|
|
|
|
|
|
|
|
|
|
A | MCC | ALARM | 2 | 4 | 6 | 8 | LANA/WAN S1L0OT |
|
|
|
| |
|
|
| 12 | 14 | 16 | 18 | ||||||
CLOBCK | SSEMRCIAML ALARM | 1 | 3 | 5 | 7 | 9 | B | 11 | 13 |
|
| |
|
|
|
|
|
|
| 15 | 17 | ||||
| D | |
| O | |
| UOCA | |
| N | |
| HHEUTION! | |
| NT | |
| UDP | |
| SEL | |
| ERA | |
| TTC | |
| PEE F | |
| UDFI | |
| LEAN | |
| LSNG | |
| I TE | |
| AG RR | |
| RN AS | |
| EAY | |
| AT | |
| SE | |
Loosen Screws | D | |
|
| |
|
| |
NOTE:
00-16793
There are two cutouts in the front face of the fan tray labeled PULL AREA. This is where you place your fingers to pull the fan tray out of the chassis.
!WARNING:
A MECHANICAL HAZARD EXISTS DUE TO ROTATING FAN BLADES. KEEP HANDS AND FINGERS AWAY FROM FAN BLADES DURING REMOVAL OF FAN TRAY. USE ONLY THE DESIGNATED PULL AREAS TO DISENGAGE THE FAN TRAY.
2 | January 2005 |