METRObility Optical Systems R200 manual AC Power Supply Connections

DC plug connector

wire leads

•Insert the plug connector into the header on the R200 and tighten the two screws.

+

48 VDC 1 AMP

DISCONNECT ALL POWER SOURCES BEFORE SERVICING +

•Turn ON the DC voltage source.

•Verify proper power connection and operation by observing that the power (PWR) LED on the line card is lit.

AC Power Supply Connections

For AC connections, follow these guidelines:

•Insert the power cord to the receptacle on the R200-AC.

•Connect the power cord plug to the AC power source.

•Verify proper power connection and operation by observing that the power (PWR) LED on the line card is lit.

8 Installation Guide