Patton electronic Patton Model 1018RC Cable Recommendations, Wire Gauge Capacitance Resistance

Page 11

APPENDIX B

PATTON MODEL 1018RC CABLE RECOMMENDATIONS

The Patton Model 1018RC operates at frequencies of 40kHz or less and has been performance tested by Patton technicians using twisted- pair cable with the following characteristics:

Wire Gauge

Capacitance

Resistance

19 AWG

83nf/mi or 15.72 pf/ft.

.0163 Ohms/ft.

22 AWG

83nf/mi or 15.72 pf/ft.

.0326 Ohms/ft.

24 AWG

83nf/mi or 15.72 pf/ft.

.05165 Ohms/ft.

To gain optimum performance from the Model 1018RC, please keep the following guidelines in mind:

Always use twisted pair wire—this is not an option.

Use twisted pair wire with a capacitance of 20pf/ft or less.

Avoid twisted pair wire thinner than 26 AWG (i.e. avoid higher AWG numbers than 26)

Use of twisted pair with a resistance greater than the above specifications may cause a reduction in maximum distance obtainable. Functionality should not be affected.

Environmental factors too numerous to mention can affect the maximum distances obtainable at a particular site. Use “maximum distance” figures as a general guideline only.

APPENDIX C

PATTON MODEL 1018RC

FACTORY REPLACEMENT PARTS

The Patton Model 1018RC rack system features interchangeable rear cards, power cords/fuses for international various operating environments and other user-replaceable parts. Model numbers, descriptions and prices for these parts are listed below.

Patton Model #

Description

1000RPEM

120/240V Rear Power Entry Module

1000RPSM-2

120/240V Front Power Supply Module

1000RPEM-DC

DC Rear Power Entry Module

1000RPSM-48A

48V Front Power Supply Module

1000RPEM-V

120/240V CE Compliant Rear Power

 

Entry Module

1000RPSM-V

120/240V CE Compliant Front Power

 

Supply Module

0805US

American Power Cord

0805EUR

European Power Cord CEE 7

0805UK

United Kingdom Power Cord

0805AUS

Australia/New Zealand Power Cord

0805DEN

Denmark Power Cord

0805FR

France/Belgium Power Cord

0805IN

India Power Cord

0805IS

Israel Power Cord

0805JAP

Japan Power Cord

0805SW

Switzerland Power Cord

0516FPB1

Single Width Blank Front Panel

0516FPB4

4-Wide Blank Front Panel

0516RPB1

Single Width Blank Rear Panel

0516RPB4

4-Wide Blank Rear Panel

056S1

Set of 16 #4 pan head screws/washers

19

20

Image 11
Contents User Manual 8AM to 5PM EST, Monday through Friday ServiceRadio and TV Interference CE NoticeDescription FeaturesFunction Card Configuration S2 Summary Table Configuration Switch Pack S1Configuration Switch SET S2 S1 Summary TableRear Card Configuration Configuration JumpersDTE Shield & Frgnd JB3 Rear Card Jumper SettingsInterface Card Strap Summary Table #1 Line Shield & Frgnd JB2Wiring the Model 1018RC Rack Power SupplySwitching the Power Supply On and Off Installing the Model 1018RC Into the ChassisTwisted Pair Connection Signal PIN#Terminal Interface Connection Remote Digital Loopback RDL POWER-UPTest Modes Local Analog Loopback LALPatton Model 1018 RC Specifications Using the V.52 BER Test IndependentlyPatton Model # Description Wire Gauge Capacitance ResistancePatton Model 1018RC Factory Replacement Parts Patton Model 1018RC Cable RecommendationsPatton Model 1018RC Interface Standards Patton Modular Interface 10 Wire RJ-45