Philips LX7000SA Connecting the speakers, Connecting a TV, Pr/Cr Pb/Cb Y In jacks on the TV

E n g l i s h

Connecting the speakers

Connect the supplied speaker systems using the supplied speaker cables by matching the colors of the jacks and speaker cables.

1Press up (or down) the clip on the speaker’s jack and fully insert the stripped portion of the speaker cable into the jack, then release the clip.

a b c

2Connect the subwoofer’s AUDIO INPUT jack to the WOOFER LINE OUT jack and then connect the speakers as follows :

Speakers	-	+
Front Right (R) (FR)	black	red
Front Left (L) (FL)	black	white
Center (C)	black	green
Surround Right (SR)	black	gray
Surround Left (SL)	black	blue

(for model LX8000SA only) Before connecting the speakers;

●Set up the speaker stands (refer to the accompanying

“Installation Guide”) or/and mount the speakers onto the mini speaker stands as shown in the illustration.

●Remove the protective cover only after the connection and installation of speakers are completed.

Notes:

–Ensure that the speaker cables are correctly connected. Improper connections may damage the system due to short- circuit.

–For optimal sound performance, use the supplied speakers.

–Do not connect more than one speaker to any one pair of +/- speaker jacks.

–Do not connect speakers with impedance lower than the speakers supplied. Please refer to the SPECIFICATIONS section of this manual.

Connecting a TV

You must connect a TV to the DVD system in order to use the DVD player.

To listen to the TV broadcast channels through the home cinema sound system

●Use the supplied audio cables to connect the system’s AUDIO-TV IN (L/R) jacks to the corresponding AUDIO OUT jacks on the TV.

IMPORTANT!

There are various ways to connect the system to a TV (as shown in the illustration below). You only need to make ONE of the best connections, depending on the capabilities of your TV system.

If your TV has a S-video input connector

●Use the S-video cable to connect the system’s S-VIDEOjack to the S-Video input jack on the TV.

If your TV has a component video (Pr/Cr Pb/Cb Y) input connector

1Use the Pr/Cr Pb/Cb Y cables to connect the system’s Pr/Cr Pb/Cb Y jacks to the corresponding

Pr/Cr Pb/Cb Y In jacks on the TV.

2for model LX8000SA only - If your TV can accept progressive signals, move the P-SCANswitch (located at rear panel) to “ON”.

Note:

– The progressive scan video quality is only possible through Pr/Cr Pb/Cb Y output.

If your TV is not equipped with Pr/Cr Pb/Cb Y or S-Video input connector

●Use the video cable to connect the system’s CVBS jack to the video input jack on the TV.

Note: On the TV,

– The S-Video In jack may be labeled Y/C, S-Video or S-VHS.

Pr/Cr

Pb/Cb

Y

					VIDEO OUT		AM
						FM 75	Ω
CDR
DIGITAL	CENTER	AUX	TV	LINE	Pr/Cr
OUT	OUT	IN	IN	OUT	CVBS		FM/AM
					Pb/Cb		ANTENNA
						P-SCAN
					Y
DIGITAL	WOOFER		AUDIO		S-VIDEO	ON OFF
IN	LINE OUT

10CONNECTIONS