Patton electronic 2155 user manual Operation, Front Panel LED Status Monitors

Page 11

4.0 OPERATION

Once the CopperLink Ethernet Extenders are properly installed, they should operate transparently. No user settings required. This section describes reading the LED status monitors.

4.1 FRONT PANEL LED STATUS MONITORS

The Model 2155 features six front-panel LEDs that monitor connections on the DSL and 10Base-T links, signaling, error and test modes. Figure 7 shows the front panel location of each LED. Table 1 describes the LED functions.

CopperLink™ Ethernet Extender

Model 2155

	Link
	DSL 10BT Status NS	ER	TM	511E/RDL
	DSL 10BT Status NS	ER	TM	Normal
				Normal
				511/RDL

DSL Status	TM	Loopback
10BT	NS ER	switch
10BT	NS ER

Figure 7. CopperLink Ethernet Extender standalone unit front panel

11

Image 11

Contents User Manual Contents CE Notice Warranty InformationRadio and TV Interference Tel. +1 301 Email support@patton.com ServiceDescription FeaturesGeneral Information Typical application Connecting the TWISTED-PAIR Line Interface Installation10Base-T Port 10Base-T DTE RJ-45 Pin No TD+ Connecting 10BASE-T Ethernet Port to PC DTEConnecting 10BASE-T Ethernet Port to HUB DCE 10Base-T Hub Connecting PowerPower Input Connector External AC universal power supplyExternal 48 VDC power supply Front Panel LED Status Monitors OperationLED Remote Digital Loopback RDL/V.52 BER Test ModesLED Status Indicators General CharacteristicsWAN Characteristics DiagnosticsDimensions ConnectorsPower Supply Temperature RangePatton Model # Description Appendix BCopperlink Interface Appendix C10BASE-T Interface RJ-45Page Page Copyright Patton Electronics Company All Rights Reserved