Patton electronic 6010 Series user manual Cabling Overview, Connector Pinouts

5.0 CABLING OVERVIEW

The interconnecting cables shall be acceptable for external use and shall be rated for the proper application with respect to voltage, current, anticipated temperature, flam- mability, and mechanical serviceability.

CAUTION

The Model 6010 Splitter Shelf cabling configurations will vary depending on installation locations and the number of lines supported by the DSLAM. However, the physical interface to the Front Panel connectors are standard 50-pin RJ-21 type receptacle connectors. Each Splitter card uses 24 pairs of the 25 pairs available on each 50-pin connector.

6.0CONNECTOR PINOUTS

•DSL signals to and from the DSLAM enter the 6010 splitter shelf using the left most telephone connectors, designated ‘DSL’ interface.

•Signals to and from the LINE (outside plant) enter the 6010 splitter shelf using the centertelephone connectors, designated ‘LINE’ interface.

•Cables to and from the central office switch enter the 6010 splitter shelf via the right hand telephone connectors, designated ‘PSTN’ interface.

Note See Table 2 on page 10 for connector pinouts.

9