Patton electronic 1017S user manual Operating the Model, Specifications

Mini Din 8 to RJ-45 Cable
Din 8	RJ-45	Signal
1 ---------------	3 --------------	HSKo (Handshake Out)
2 ---------------	2 --------------	HSKi (Handshake In)
3 ---------------	6 --------------	TD- (Transmit Data-)
4 ---------------	4 --------------	Gnd (Ground)
5 ---------------	5 --------------	RD- (Receive Data-)
6 ---------------	4 --------------	TD+† (Transmit Data)
7 -------------	N/C-------------	GPi
8 -------------	N/C-------------	RD+ (Receive Data)

†TD+ is connected to ground

3.3 OPERATING THE MODEL 1017

Once the Model 1017 is properly installed, it should operate trans- parently—as if it were a standard cable connection. Operating power is derived from the Mac's data and control signals; there is no “ON/OFF” switch.

APPENDIX A

SPECIFICATIONS

Transmission Format: Asynchronous

Data Rate: 300 to 19,200 bps

Data Protection: High speed surge protection and transformer isolation (Model 1017S only)

Distance:		See table below
Surge Protection:		600W power dissipation at 1 mS and
		response time of 1.0 pS (Model 1017S only)
Control Signal:		The single Mac control line, Handshake In,
		turns on when the modem is connected
Transmit Line:		4-wire, unconditioned line (2 twisted pairs)
Transmit Mode:		Full duplex
Transmit Level:		0 dBm
Line Connection:		RJ-11, RJ-45
Power Supply:		No external power required, uses ultra low
		power from data and control signals
Size:		2.0” x 1.7” x 0.8”
	Distance Table (miles)
	Data Rate			Wire Gauge
			19		24	26
	19,200		2.5		1.8	1.2
	9,600		5.5		3.7	2.5
	4,800		7.5		5.0	3.0
	2,400		8.5		5.6	3.7
	1,200		9.0		6.2	4.3

5 6