Patton electronic 9300, 9200 Introduction, Model 9100 E1 Module, Unpacking and Installation

Read the safety information in the OnSite Series Getting Started Guide and Administrator’s Reference Guide thoroughly before installing and operating your OS-10 Series system. Failure to follow this safety infor-

WARNING mation can lead to personal injury or damage to the equipment.

1.0 Introduction

This guide provides instructions for adding expansion modules to your Patton OnSite base system. Refer to the following sections for installation instructions for your specific module:

•2.0 “Model 9100 E1 Module” on page 2

•3.0 “Model 9200 Ethernet Module” on page 4

•4.0 “Model 9300 STM-1 Module” on page 5

2.0Model 9100 E1 Module

2.1Unpacking and Installation

To install the HD-E1 module, follow the procedures in Chapter 7 of the OnSite Series Administrator’s Reference Guide. Figure 1 shows the alignment and insertion of the HD-E1 module into one of the available expansion slots of the OS-10.

The High-density E1 module is NOT hot swappable. You will need to power down the OS-10 system before starting the module insertion pro- cedure.

CAUTION

Figure 1. Installing the HD-E1 module

2 OnSite Expansion Modules Quick Start Guide