|
|
| rn | e | t |
| th | e |
|
| |
E |
|
|
|
| |
|
|
|
|
| |
|
|
|
|
| 1 |
2 |
|
|
|
| |
|
|
|
| US | A |
|
|
| the |
| |
|
| in |
|
| |
| de |
|
|
| |
Ma |
|
|
|
| |
|
|
|
|
|
Power
L | in | e |
|
|
Power
jack
CopperLINK
Dual 10/100
Ethernet ports
Figure 2. Model 2168B standalone rear panel
3.1 CONNECTING THE TWISTED-PAIR LINE INTERFACE
The Interconnecting cables shall be acceptable for
external use and shall be rated for the proper applica-
tion with respect to voltage, current, anticipated tem-
CAUTION perature, flammability, and mechanical serviceability.
The Model 2168B supports communication between two peer Ethernet LAN sites over a distance of up to 4,250 ft (1.3 km) over 24 AWG (0.5 mm)
Note Actual distance and link performance may vary depending on the environment and type/gauge of wire used.
Follow the steps below to connect the Model 2168B CopperLINK Inter- faces.
Note The Model 2168B units work in pairs. One of the units must be configured as a (L) Local unit, and the other unit must be config- ured as a (R) Remote unit. It does not matter which end is the L and which is the R. The link is always initiated by the R unit. As long as the L unit is powered on, the R unit can establish a link by being powered on or by having its power reset.
10