Unpacking and Installation | Patton electronic 07MOS10xx-QS specification

Read the safety information in the OnSite Series Getting Started Guide and Administrator’s Reference Guide thoroughly before installing and operating your OS-10 Series system. Failure to follow this safety infor-

WARNING mation can lead to personal injury or damage to the equipment.

1.0Unpacking and Installation

1.Check the contents of the shipping container and accessories box or bag against the content list and the packing slip. Verify that you received all listed equipment and inspect all items for shipping damage.

2.Unpack the OS-10 Series chassis and install it into a rack according to the instructions in the OnSite Series Getting Started Guide on the CD-ROM shipped with your unit.

3.Verify that the site where you wish to install and operate the equipment conforms to the environmental requirements in the OnSite Series Getting Started Guide.

2.0Powering Up the System

If your OS-10 Series system was ordered for use with AC power, follow these steps:

	For your safety and to avoid damage to the equipment, follow the pre-
	cautions, instructions and wiring procedures in the OnSite Series Getting
	Started Guide before connecting the OS-10 Series system to an AC or DC
WARNING	power source.

1.Connect the enclosed AC power cable to the AC power receptacle on the rear side of the OS-10 Series chassis.

2.Connect the power cable plug to an AC power source with the following characteristics: 15 A at 120 VAC (60 Hz) or 10 A at 240 VAC (50 Hz) circuit with overcurrent protection.

Refer to the OS-10 Series Installation and Operation Guide if your system was ordered for use with DC power (– 48 VDC nominal).

When you ﬁrst apply power to the system, the STAT (status) LED on the front panel becomes a solid amber light. This light indicates that the system is booting. The STAT LED becomes a solid green light when the system com- pletes the boot process and is ready for management access and operation.

2	OnSite Series Quick Start Guide