TP-Link TF-3239DL appendix Introduction, Copyright & Trademarks FCC Statement, Safety Notices

COPYRIGHT & TRADEMARKS

Specifications are subject to change without notice. is a registered trademark of TP-LINK Technologies Co., Ltd. Other brands and product names are trademarks or registered trademarks of their respective holders.

No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK Technologies Co., Ltd. Copyright © 2005 TP-LINK Technologies Co., Ltd. All rights reserved.

FCC STATEMENT

The adapter has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

ØReorient or relocate the receiving antenna.

ØIncrease the separation between the equipment and receiver.

ØConsult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference.

(2)This device must accept any interference received, including interference that may cause undesired operation.

EC DECLARATION OF CONFORMITY (EUROPE)

In compliance with the EMC Directive 89/336/EEC, the adapter meets the requirements of the following standards:

ØEN55022

ØEN55024

SAFETY NOTICES

Caution:

Do not use this product near water, for example, in a wet basement or near a swimming pool.

Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning.

Thank you for purchasing TF-3239 series 10/100M Fast Ethernet Adapters. This guide is to provide the installation and usage of the Products for network installers or users. The Product complies with PCI 2.1/2.2 specification and supports half/full duplex feature which can double network speed.

The Adapters support both 10Mbps and 100Mbps network speed, 100Base-TX operates on twisted pairs of Category 5 UTP and 10Base- T operates on Category 3, 4, 5 UTP. The Products use Auto- Negotiation technology to detect the network speed. Extensive driver supports for including commonly used network operation system Netware, Win9x,Win2000, Windows NT, and TCP/IPare available.

This manual is divided into two chapters and two appendices. The following summarizes the contents of the chapters and appendices.

Chapter 1 Introduction

Hardware Overview

TF-3239 series Adapters are highly integrated and cost-effective single-chip Fast Ethernet Adapter that provides 32-bit performance, PCI bus master capability, and full compliance with IEEE 802.3u 100Base-TX specifications and IEEE 802.3x Full Duplex Flow Control. They also support ACPI, PCI power management for modern operating systems that is capable of Operating System Directed Power Management (OSPM) to achieve the most efficient power management.

The Adapters keep network maintenance cost low and eliminate usage barriers. It is the easiest way to upgrade a network from 10 to 100Mbps. The product is highly integrated and requires no "glue" logic or external

memory.

It includes an interface for a boot ROM and can be used in diskless workstations, providing maximum network security and ease of management(Exclude TF-3239DL).

They also support full-duplex operation, making possible 200Mbps of bandwidth at no additional cost. The Adapters support both 10Mbps and 100Mbps network speed, 100Base-TX operate on twisted pairs of Category 5 UTP and 10Base-T operate on Category 3, 4, 5 UTP. The Adapters use Auto-Negotiation technology to detect the network speed. Extensive driver supports for including commonly used network operation system Netware, Win9x,Win2000, Windows NT, and TCP/IP are available.

Whatever your requirements are ease of installation, superior performance, or responsive support backed up by unlimited technical support, the Product is the superior choice.

Features & Benefits

ØIntegrated Ethernet MAC, Physical chip and transceiver in one chip

ØCompliant to PCI Revision 2.1/2.2

ØPCI local bus single-chip Ethernet controller

ØSupports PCI clock 16.75MHz-40MHz

ØSupports a 32-bit general-purpose timer, referenced by the external PCI clock source, and timer-interrupt

ØIncludes a programmable, PCI burst size and early Tx/Rx threshold

ØSupports PCI target fast back-to-back transaction

ØSupports digital and analog loopback capability on both ports

1 2