Rear-panel, Hardware installation procedures

TD-8811/8811B

External ADSL2+ ROUTER

2.3Rear-panel

¾ON/OFF: Turn on/off the ADSL2+ Router’s power.

¾POWER (9VAC/0.8A input): please do not use any unknown power adapter, otherwise your ADSL2+ Router may be damaged.

¾RESET (reset default): Press the reset button, then turn on the Router's power (keep the button pressed) for at least three seconds, it will restore the settings to the default factory configuration.

¾LAN: Connect with your computer’s NIC.

¾USB: Connect with your computer’s USB interface

¾LINE (WAN): Connect to the MODEM Port of Splitter or connect the telephone line.

2.4Hardware installation procedures

The procedure to install the Router can be described in the following steps:

First Step: Connect the MODEM port of Splitter with the LINE port of the TD-8811/TD-8811B ADSL2+ ROUTER by telephone line.

Second Step: Connect category 5 cable with RJ45 jacks to ADSL2+ Router’s LAN port and your computer’s NIC. Or connect USB cable to ADSL2+ Router’s USB port and your computer’s USB interface.

Third Step: Plug one end of the AC Power Adapter into the Power jack on the Ethernet ADSL2+ Router and the other end to a standard electrical outlet.

Last Step: Check the line connection to see if everything is ready. Power up finally.