TP-Link TL-SF1008P manual Identifying External Components, Power On, Front Panel

Page 11

2.2 Power On

The TL-SF1008P Switch can be used with DC power supply. Powering on the Switch, it will automatically initialize and its LED indicators will respond as follows:

1)Firstly, the Power LED indicator will light up.

2)Then, the 100Mbps and Link/Act LED indicators will flash momentarily for one second, which represents a resetting of the system.

Note

If the LED indicators don’t respond as described above, please check the power supply and its connection.

Chapter 3. Identifying External Components

This Chapter describes the front panel, rear panel and LED indi- cators of the Switch.

3.1 Front Panel

Figure 3-1 TL-SF1008P Switch Front Panel

The Switch’s LEDs are located on the front panel.

5

Page 10 Page 12
Image 11
Page 10 Page 12
Contents
User Guide Page Copyright & Trademarks FCC Statement Safety Notices Appendix a Specifications Package ContentsInstallation Package Contents Overview of the Product Introduction of the ProductConvention FeaturesMounting the Switch on a Desk InstallationFront Panel Power OnIdentifying External Components Name Status Indication Following parts are located on the rear panel Rear PanelPage General Appendix a SpecificationsEnvironmental and Physical
Top Page Image Contents