ZyXEL Communications omni.net Plus, omni.net D quick start Power On and Self Diagnostics

Page 10

omni.net Plus/D Quick Start Guide

Power On and Self Diagnostics

Once you have completed all of the installation steps above, flip the omni On/Off switch to the ON (up) position.The unit starts a self-test sequence, where you should see a series of LED lights blinking (LED, B1, B2, AA). After this cycle is complete, the PWR light should stay on.

If the test routine fails, the LNK LED flashes. Refer to your omni.net Plus/D Technical Reference for more information on self-tests and error codes.

If you have a communication program loaded and active (connected to the same serial port as

the omni), you should see the DTR LED should be ON after the self-test.

1-6

Image 10
Contents ZyXEL Page Table of Contents Page Installation Front Panel DescriptionFront Panel LEDs Front Panel Switch Back Panel Switch and Connectors Back Panel Description and Connections S/T InterfaceConnect Your omni.net Plus/D U interface to Isdn Line Power On and Self Diagnostics Install Windows 95/98/NT Driver INF file Before InstallationStart Installing INF file Omni.net Plus/D Quick Start Guide Click OK to install INF files from your Bonus CD Omni.net Plus/D Quick Start Guide Select the COM port your omni.net PLUS/D is connected Please wait… Click Finish to complete INF files installation Click Close to end the INF files installation Page Please wait for the next setup screen Please wait for the next screen Welcome information Information about ZyXEL Isdn Configuration Manager Select install item Choose Destination Location Omni.net Plus/D Quick Start Guide Start copying files to the following directory Click Ok to finish the installation Page Setup ZyXEL Isdn Configuration Manager for Windows ZyXEL