ZyXEL Communications Comet 336P user manual ATXn Result Code Option Table

Page 29

Sets the length of time, in tenths of a second, that the modem waits before hanging up after a loss of carrier. This allows for a temporary carrier loss without causing the local modem to disconnect.

S11 - DTMF Tone Duration

Sets the duration of tones in DTMF dialing. This value has no effect on pulse dialing.

S12 - Escape Prompt Delay (EPD)

Defines the maximum period, in fiftieths of a second, allowed between receipt of the last character of the three escape character sequence from the DTE and sending of the OK result code to the DTE. If any characters are detected during this time, the OK will not be sent. Note that sending of the OK result code does not affect entry into command mode.

S18 - Test Timer

Sets the length of time, in seconds, that the modem conducts a test (commanded by &Tn) before returning to the command mode. If this register value is zero, the test will not automatically terminate; the test must be terminated from the command mode by issuing an &T0 or H command. When S18 is non-zero, the modem returns the OK message upon test termination.

S25 - Delay To DTR

Sets the length of time that the modem will ignore DTR for taking the action specified by &Dn. Its unit is one hundredth of a second.

S26 - RTS to CTS Delay

Sets the time delay, in hundredths of a second, before the modem turns CTS ON after detecting an OFF-to-ON transition on RTS when &R0 is commanded.

S30 - Disconnect Inactivity Timer

Sets the length of time, in minutes, that the modem will stay online before disconnecting when no data is sent or received. In error-correction mode, any data transmitted or received will reset the timer. In other modes, any data transmitted will reset the timer. Set S30=0 to disable the timer.

Result Code Options

"ATXn" Result Code Option Table

The following table shows the different options available when setting the ATXn command:

ATV0

ATV1

X0

X1

X2

X3

X4

X5

X6

X7

0

OK

V

V

V

V

V

V

V

V

Status Registers & Result Codes 23

Page 28 Page 30
Image 29
Page 28 Page 30
Contents Comet 336P User’s Manual FCC Part 15 Information Limited WarrantyAcknowledgments Contacting ZyXEL FCC Requirements∙ E-mail Table of Contents AT Command Set Summaries Unpacking Your Modem IntroductionHardware Overview Required EquipmentIntroduction Using INF file in the bundled diskette InstallationHardware WindowsDOS Technical Notes for Enabler Fax/Modem EnablerIRQ Number Address Windows NTClick the Finish button Installation Installation Basic Modem Operation Understanding AT CommandsUsing the Windows 95 Hyper Terminal Program Dialing and Answering Techniques Dialing using the ATD CommandAuto-Answer and Hook Controls Making Your First ConnectionATS0=n ATS0=0AT Command Set/Type Example Quick Tips when issuing AT CommandsCommand Description Changing S Register Values Modem Result CodesViewing S Register Values Non-Volatile Memory Saving Settings and User ProfilesStoring Phone Numbers Dialing Stored Phone NumbersAT Command Description Default Modem Settings for PC’sBasic Modem Operation Basic AT Command Set AT Command Set SummariesMNP4+MNP5 Extended AT& Command Set9600/7200T/4800 Extended AT* Command Set Registers ATSn=x Status Registers & Result CodesRegister Definitions Page ATXn Result Code Option Table Result Code Field Descriptions Result Code Chart Symbol Reference
Top Page Image Contents