Interpreting LED Indicators
LED | Status | State | Interpretation |
Power | Power status | On | Converter is on. |
|
| Off | Converter is off. |
Link | Fiber link | On | The fiber link is ok. |
|
| Off | No link or the link is faulty. |
Rx | Receiving status | Blink | Receiving is in operation. |
|
| Off | No fiber receiving. |
Link | UTP link | On | The UTP link is ok. |
|
| Off | No link or the link is faulty. |
Rx | Receiving status | Blink | Receiving is in operation. |
|
| Off | No fiber receiving. |
The information contained in this document is subject to change without prior notice.
Copyright Ó KTI. All Rights Reserved.
TRADEMARKS
Ethernet is a registered trademark of Xerox Corp.
WARNING:
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protec- tion against harmful interference when the equipment is operated in a commercial environment. This equipment gener- ates, uses, and can radiate radio frequency energy and if not installed and used in accordance with the instruction manual may cause harmful interference in which case the user will be required to correct the interference at his own expense.
NOTICE:
(1)The changes or modifications not expressively approved by the party responsible for compliance could void the user's authority to operate the equipment.
(2)Shielded interface cables and AC power cord, if any, must be used in order to comply with the emission limits.
CISPR A COMPLIANCE:
This device complies with EMC directive of the European Community and meets or exceeds the following technical standard.
EN 55022 - Limits and Methods of Measurement of Radio Interference Characteristics of Information Technology Equip- ment. This device complies with CISPR Class A.
WARNING: This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.
CE NOTICE
Marking by the symbol CE indicates compliance of this equipment to the EMC directive of the European Community. Such marking is indicative that this equipment meets or exceeds the following technical standards:
EN 55022: Limits and Methods of Measurement of Radio Interference characteristics of Information Technology Equip- ment.
EN 50082/1:Generic Immunity Standard
EN