Lindy P16-IP IP auto configuration, Subnet Mask, Gateway IP address, Http port, Telnet port

Section 4 IP Access Configuration & Operation

IP auto configuration

With this option you can control if the P16-IP should obtain its network settings from a DHCP or BOOTP server. For DHCP, select dhcp, and for BOOTP select bootp. If you choose none then IP auto configuration is disabled.

IP address

IP address in the usual dot notation.

Subnet Mask

The net mask of the local network.

Gateway IP address

In case the P16-IP is accessible from networks other than the local one, this IP address must be set to the local network router©s IP address.

Primary DNS Server IP Address

IP address of the primary Domain Name Server in dot notation. This option may be left empty; however, the P16-IP will not be able to perform name resolution.

Secondary DNS Server IP Address

IP address of the secondary Domain Name Server in dot notation. It will be used in case the Primary DNS Server cannot be contacted.

Remote Console and HTTPS port

Port number at which the P16-IP’s Remote Console server and HTTPS server are listening. If left empty the default value will be used.

HTTP port

Port number at which the P16-IP’s HTTP server is listening. If left empty the default value will be used.

Telnet port

Port number at which the P16-IP’s Telnet server is listening. If left empty the default value will be used.

Bandwidth limitation

The maximum network traffic generated through the P16-IP’s Ethernet device. Value in Kbit/s.

Enable Telnet access

Set this option to allow access to ARA express using the Telnet Gateway (see the Section

called Telnet Console on page 36.)

Disable Setup Protocol

Enable this option to exclude the P16-IP from the setup protocol.

54